Cable Locations - Xerox DocuPrint 100 Installation Planning Manual

System connections

Cable locations

7-2
Using an inappropriate alternate cable may degrade the
performance of your equipment and may also be hazardous.
NOTE: Cable length loss must be factored in if equipment is
installed in a raised-floor environment. You should also consider
that part of the length of a cable is routed inside the equipment to
connect with interior power or data receptacles.
To run the cables beneath the flooring, you must know where the
cables enter and exit the printer. The following diagrams shows
that location marked with an X.
Figure 7-1. Cable enter/exit location (top view)
1. Back of printer area
2. Printer with feeder/stacker modules
3. Front of printer area
All power cords attach to the back of the printer. Power cord
distances from the left end of the printer (as you face it) are:
• DP 100, 115, and 135–distance from end of printer:
14 inches / 356 mm
• DP 155 and 180–distance from end of printer:
– Cord 1: 36 inches / 914 mm (with ELCI)
– Cord 2: 23 inches / 584 mm (with ELCI)
WARNING
Installation Planning Guide