Your Responsibilities - Xerox DocuPrint 100 Installation Planning Manual

Installation

Your responsibilities

8-2
4. Xerox personnel test the system and run sample jobs (30
minutes).
5. Xerox personnel conduct initial operations training (four to six
hours).
6. Xerox personnel review preventive maintenance schedules
and service call procedures.
Xerox personnel are responsible for the physical installation of
the printer components and for loading the software and
applications. You have the general site responsibility of ensuring
that the right personnel, supplies, and network information are
available.
At the time of installation, you should do the following:
• Make sure that your system administrator is available during
the loading of software.
• For software loading purposes, be prepared to provide Xerox
personnel with network information from the preinstallation
worksheets. Refer to the Getting Ready for Installation
manual for specifics regarding network information.
• Designate two client workstations for downloading Xerox
client software if applicable: one for initial system validation
and another for use in operator training provided by your
systems analyst.
• If your system will be connected to an IBM host through a
channel, provide the host channel address, channel unit
address, and data transfer mode.
• If your system will be connected to an IBM host through
Socket TCP/IP, provide the host IP address and port number.
• Check the documentation and software kits with their packing
lists for completeness.
• Load Xerox client software on any additional client
workstations.
Remember that you are responsible for supplying, installing,
and maintaining your client workstations and the Ethernet
local area network (LAN) that connects them with the printing
system.
• Have test jobs ready to run.
Installation Planning Guide