Xerox DocuPrint 100 Installation Planning Manual page 49

Enterprise printing system
Hide thumbs Also See for DocuPrint 100:
Table of Contents

Advertisement

Site personnel
Operator and
systems training
Site preparation
Network
installation
Channel-attached
printing
Client
workstations
Installation Planning Guide
NOTE: Operating system software is not the same for all printing
systems. Therefore, make sure that your system specialists are
familiar with the operating system software that is specific to your
DocuPrint system. If your system specialists are familiar with one
operating systems and you are converting to, or adding another,
they should be familiar with the differences.
Identify the person (or persons) at your site who will be the
primary interface with Xerox.
After the installation of the printing system, there are a few
ongoing tasks that must be performed. These tasks may include
all or some of the following:
Meter reading and reporting
Overseeing routine maintenance
Placing service calls for hardware problems
Ordering additional documentation, software, or fonts
Arranging additional operator training
Maintaining an adequate inventory of consumable supplies.
It is your responsibility to designate a person (or persons) to
perform these tasks.
Select personnel for operator and systems training and set up a
training schedule.
Select and prepare the site for system installation (including
proper power, air conditioning, and work space). If connecting to
other equipment, obtain the necessary interfaces, cables,
transceivers, phone lines, and so forth.
Install the necessary network components required to connect
client workstations to the printing system. Refer to the Getting
Ready for Installation manual for details.
Obtain and install fully populated bus and tag cables required to
connect the host to the printing system. Refer to the Getting
Ready for Installation manual for details.
Make sure all client workstations that will be submitting print jobs
have the proper hardware, operating system, and networking
software required by the printing system as client platforms.
Preparing for installation
4-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docuprint 115Docuprint 135Docuprint 155Docuprint 180

Table of Contents