Setting Gear Change Light Limits - Triumph Daytona 955i Handbook

General Information
LED RPM
1250rpm
st
1 green LED
set
speed
1000rpm
nd
2 green LED
set
speed
750rpm
rd
3 green LED
set
speed
500rpm
st
1 amber LED
set
speed
250rpm
nd
2 amber LED
set
speed
2 red flashing Set
LED's all other speed
LED's off
All LED's off 500rpm
set
speed
Once the set rev limit has been
exceeded by 500 rpm, the lights will
go out until the engine revs are 500
rpm below the set limit.
The gear change lights will not
operate below 3500 rpm to avoid the
lights operating at idle.
30
Setting Gear Change Light
Limits
before
To reset
change-up
settings, turn on the ignition only.
Press the 'trip' and 'scroll' buttons
before
simultaneously for 4 seconds, after 4
change-up
seconds the tachometer needle will
move round to the last set position
and the word 'tAcHo' will appear in
before
the clock display.
change-up
Press the 'set' button for 4 seconds,
after 4 seconds the rev limit will be
before
set to 0.
change-up
• Pressing
again at this point will turn
before
off the gear change lights.
change-up
To change the setting in increments
of 1000
button. The first press will start the
change-up
setting at 3500 rpm. Each individual
press will then increase the settings
in increments of 1000 rpm.
above
When the correct setting is shown
change-up
press the 'set' button to confirm.
The setting can now be changed in
increments of 100 rpm.
When the correct setting is shown,
pressing the 'set' button will confirm
the setting.
the gear change light
the 'set' button
rpm, press the 'scroll'