Triumph Daytona 955i Handbook page 100

Maintenance and Adjustment
Headlight Bulb Replacement
1
2
cbnp
1 Headlight bulb
2 Bulb clip
3 Position lamp bulb
Warning
The bulbs become hot during use.
Always allow sufficient time for the
bulbs to cool before handling.
Avoid touching the glass part of
the bulb. If the glass is touched or
gets dirty, clean with
before re-use.
Remove the seat.
Disconnect the battery,
(black) lead first.
Undo the fixing securing
headlight clamp to the headlight
body.
Support the headlight
removing the clamp.
100
Remove the headlight from its bowl
while supporting it to prevent the
cables from being over extended.
Disconnect the multi-pin electrical
connector
replaced and remove the rubber
cover.
Detach the wire retainer from its clip
(do not remove the screw) then
remove the bulb from the light unit.
Remove the bulb from the headlight
unit.
3
To remove the position lamp bulb:
Without pulling the wires, ease the
bulb holder from its socket. The bulb
is removed from its holder by pulling
gently upwards.
Installation for both bulbs is the
reverse of the removal procedure.
Tighten the
4 Nm.
When reconnecting the battery,
connect the positive (red) lead
first.
alcohol
negative
Do not reconnect the battery until
the assembly process has been
the
completed.
reconnection
ignition of
while
causing risk of injury.
from the bulb to be
headlamp clamp to
Caution
Warning
Premature battery
could result in
the battery gases