Service Interval Announcement (Sia); Gear Change Lights - Triumph Street Triple S Owner's Handbook Manual

GENERAL INFORMATION
88
Service Interval Announcement
(SIA)
The Service Interval Announcement (SIA)
shows the total distance that the
motorcycle has remaining before a
service is required.
1. Service symbol
2. Remaining distance
When the remaining distance is 0 miles
(0 km) the service symbol will remain on
until the service has been carried out
and the system has been reset by your
authorised Triumph dealer.
If the service is overdue, the distance
will be shown as a negative number.
When the ignition is switched on and
the distance to the next service is 500
miles (800 km) or less, the service
symbol will be shown for three seconds
and the clock will show the distance
remaining before the next service.
1
2

Gear Change Lights

Note
The gear change lights will not operate
below 3,500 rpm to avoid the lights
operating at idle.
3
1
4
1. Gear change lights
2. Display screen (6 mode shown)
3. SCROLL Button
4. SET Button
Changing the Gear Change Light Modes
To change the gear change light modes:
▼ Press and release the SCROLL button
until SEtUP is shown in the display
screen then press the SET button.
▼ Press and release the SCROLL button
until SHIFt is shown then press the
SET button. The current mode will be
shown and the corresponding gear
change lights will illuminate.
▼ Press and release the SCROLL button
until the required gear change light
mode is shown then press the SET
button. The display will scroll through
in the following order:
– 6 (6 LED mode);
– 3 (3 LED mode);
– SE (Sequential mode);
– OFF (Gear change lights off).
2