Connections; Recording An Outgoing Message (Ogm); Multi-Line Connections (Pabx) - Brother MFC-9125CN User Manual

Chapter 7

Connections

The external TAD must be connected as
shown in the illustration below.
(Example for Australia)
1 TAD
2 Protective Cap
a
Set your external TAD to one or two
rings. (The machine's Ring Delay
setting does not apply.)
b
Record the outgoing message on your
external TAD.
c
Set the TAD to answer calls.
d
Set the Receive Mode to
External TAD. (See Choosing the
receive mode on page 46.)
58
7
1
1
2
Recording an outgoing
message (OGM)
a
Record 5 seconds of silence at the
beginning of your message. This allows
your machine time to listen for fax tones.
b
Limit your speaking to 20 seconds.
c
End your 20-second message by giving
your Remote Activation code for people
sending manual faxes. For example:
"After the beep, leave a message or
press l51 (l91 for New Zealand) and
Start to send a fax."
Note
• You need to turn the Remote Codes
setting to on to use the Fax Activation
Code l51 (l91 for New Zealand). (See
Using Remote Codes on page 60.)
• We recommend beginning your OGM with
an initial 5 second silence because the
machine cannot hear fax tones over a loud
voice. You may try leaving out this pause,
but if your machine has trouble receiving
faxes, then you should re-record the OGM
to include it.

Multi-line connections (PABX)

Most offices use a central telephone system.
Brother recommends that all our Fax/MFC
machines be connected to a discreet
(dedicated) line. Although a particular PABX
may appear to work with a particular model of
fax machine, we cannot guarantee that the
unit will operate correctly.
While it is often relatively simple to connect a
fax machine to a PABX (Private Automatic
Branch Exchange), we suggest that you
contact the company that installed your
telephone system and ask them to connect
the fax machine for you.
Brother does not recommend the use of a
PABX line. PABX limitations in general can
cause some functions of the fax machine not
to work correctly.
7
7