Scanning Difficulties; Software Difficulties - Brother MFC-9125CN User Manual

Printing difficulties (continued)
Difficulties
The machine prints unexpectedly
or it prints garbage.
The machine prints the first couple
of pages correctly, then some
pages have text missing.
The headers or footers appear
when the document displays on the
screen but they do not show up
when it is printed.
The machine is not printing or has
stopped printing.

Scanning difficulties

Difficulties
TWAIN errors appear while
scanning.
OCR does not work.
Network scanning does not work.
Cannot scan.

Software difficulties

Difficulties
Cannot install software or print.
Cannot perform '2 in 1' or '4 in 1'
printing.
The machine does not print from
® ®
Adobe Illustrator .
Suggestions
 Pull out the paper tray and wait until the machine stops printing. Then turn off
the machine and disconnect from the power for several minutes. (The
machine can be turned off for up to 60 hours without losing faxes stored in the
memory.)
 Check the settings in your application to make sure it is set up to work with
your machine.
 Check the settings in your application to make sure that it is set up to work with
your machine.
 Your computer is not recognising the machine's input buffer's full signal. Make
sure that you connected the interface cable correctly. (See the Quick Setup
Guide.)
There is an unprintable area on the top and bottom of the page. Adjust the top and
bottom margins in your document to allow for this. (See Unprintable area
on page 17.)
Press Job Cancel.
As the machine cancels the job and clears it from the memory it may produce an
incomplete printout.
Suggestions
Make sure that the Brother TWAIN driver is chosen as the primary source. In
PaperPort™ 11SE, click File, Scan or Get Photo and choose the Brother TWAIN
driver.
Try increasing the scanning resolution.
See Network difficulties on page 135.
(For MFC-9325CW only) Contact your administrator to check your Secure
Function Lock Settings.
Suggestions
Run the Repair MFL-Pro Suite program on the CD-ROM. This program will repair
and reinstall the software.
Check that the paper size setting in the application and in the printer driver are the
same.
Try to reduce the print resolution. (See Advanced tab in the Software User's Guide
on the CD-ROM.)
Troubleshooting and routine maintenance
C
133