Brother MFC-9125CN User Manual page 131

24 Unplug this product from the mains power and telephone line sockets, and refer servicing to
qualified Service Personnel under the following conditions:
 If the power cord is damaged or frayed.
 If liquid has been spilled into the product.
If the product has been exposed to rain or water.

 If the product does not operate normally when the operating instructions are followed.
Adjust only those controls that are covered by the operating instructions. Incorrect
adjustment of other controls may result in damage and will often require extensive work by
a qualified technician to restore the product to normal operation.
 If the product has been dropped or the casing has been damaged.
 If the product exhibits a distinct change in performance, indicating a need for service.
25 This unit will only work in conjunction with a tone signalling (DTMF) telephone, but some
telephones are not compatible. Since noise or speech from the telephone can upset dialling
from this unit, errors may result if the devices are used together in other than quiet conditions.
26 Where it is necessary to dial prefix digits, such as a Caller Display override code ("0196" or
"0197"), this unit will have to be used in conjunction with an associated tone signalling (DTMF)
telephone.
27 Note that some telephones are not compatible with this unit and dialling errors may result if the
two devices are used together in other than quiet conditions. The Telecom Faults Service is
not to be called should such problems arise. In such cases, it is recommended that the prefix
and wanted number are dialled manually.
28 This equipment may not provide for the effective hand-over of a call to another device
connected to the same line.
29 This equipment is not capable, under all operating conditions, of correct operation at the higher
speeds for which it is designed. Telecom will accept no responsibility should difficulties arise
in such circumstances. This condition typically applies to 56 kbit/s modems and facsimile
products operating at >14.4 kbit/s.
30 When using the Caller Line Identification incorporated in this device, verify the integrity of the
recorded digits prior to dialling.
31 Some parameters required for compliance with Telecom's Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment shall
be set to operate within the following limits for compliance with Telecom's Specifications:
There shall be no more than 10 call attempts to the same number within any 30 minute

period for any single manual call initiation, and
 The equipment shall go on-hook for a period of not less than 30 seconds between the end
of one attempt and the beginning of the next call attempt.
 Automatic calls to different numbers are spaced such that there is not less than 5 seconds
between the end of one call attempt and the beginning of another.
 Equipment shall be set to ensure that calls are answered within 3 and 30 seconds of the
receipt of ringing.
Safety and legal
A
119