Becker Ready 50 Operating Manual page 50

>>> NAVIGATION MODE
Note:
> D
The symbols above the progress bar
refer to restrictions that you may have
> GB
activated (e.g. unpaved roads, toll
> F
roads).
If the route guidance is already running
> I
you will be asked whether the new
> PL
destination should replace the old
destination or if the new destination
should be regarded as a waypoint.
> Select Add as stopover
destination .
50
If the route guidance is already running
and a waypoint has already been entered
you will be asked whether the new
destination should replace the old
destination or the waypoint.
> Select Replace stopover
old destination
or Replace old
Note:
If there is no GPS signal when the route
is calculated, the following will be
displayed:
When a GPS signal is available, the route
or Replace
calculation will start automatically.
.
When the
pressed, the last known position is used
and the route calculated from this
position.
Last position
button is