Expansion Board Options - HP ProLiant ML100 Series User Manual

Open the DIMM slot latches.
5.
Install the DIMM.
6.
Ins ll the air baffle. ta
7.
Install the access panel.
8.
Do one of the following:
9.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
If you are installing DIMMs in lock-step configuration, configure this mode in
Utility" on page 30).
For more information about LEDs and troubleshooting failed DIMMs, see the s
the HP website (http://www.hp.com/go/bizsupport).

Expansion board options

For server-specific expansion board installation instructions, refer to the installation
the server.
CAUTION:
remove all AC power cords before removing or installing the expansion boards.
To install the compon
Po we r down the server
1.
Do one of the following:
2.
Unlock and remove the bezel
o
Extend the server from the rack.
o
Remove the access panel (on page 6).
3.
To prevent damage to the server or ex
ent:
(on page 6).
("Remove the tower
RBSU
erver installation sheet on
sheet that ships with
pansion boards, power down the server and
bezel" on page 6).
Hardware options installation 24
("ROM-Based Setup