HP ProLiant ML100 Series User Manual page 22

•
If quad-rank DIMMs are installed for a processor, a maximum of two DIMMs can be installed on
each channel for that processor.
If a channel conta
DIMM speeds
Pop ula ed slots t
(per ch nnel) a
1
1
2
2
Advanc ed ECC population guidelines
For Advanced ECC mode configu
•
Observe the general DIMM slot population gu
•
DIMMs may be installed individually.
Single-processor Advanced
For Advanced ECC mode configurations with a single processor, populate the DIMM slots in the following
order:
•
RD IMM: Sequentially in alphabetical order (A through F)
•
UDIMM: S
Mult i-processor Adv
For Advanced ECC mode configurations with multiple processors, populate the DIMM slots for each
proc ess r in the following order: o
•
RDIMM: Sequentially in alphabetical order (A through F)
•
UDIMM: Sequentially in alphabetical order (A through F).
Lockstep Memory popu
For Lock ep memory mode configurations, observe the following guidelines: st
•
Observ e the general DIMM slot population guidelines (on page 21).
•
Always install DIMMs in channels 1 a
•
Do not install DIMMs in ch
•
DIMM configuration on channel 1 and channel 2 of a processor must be id
•
In multi-processor configurations, each pr
•
In multi-processor config
configuration.
ins quad-rank DIMMs, the quad-rank DIMM must be installed first on that channel.
are supported as indicated in the following table.
Ran k
Single- or dual-rank
Quad-rank
Sing le- or dual-rank
Sin gle-, dual-, or quad-rank
rations, observe the following guidelines:
ECC population order
equentially in alphabetical order (A through F).
anced ECC population order
lation guidelines
annel 3 for any processor.
urations, each pr
Speeds supported
(MHz)
800, 1333, 1066
800, 1066
800, 1066
800
idelines (on page 21).
nd 2 for each installed processor.
ocessor must have a valid Lockstep Memory configuration.
ocessor may have a different valid Lockstep Memory
entical.
Hardware options installation 22