FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual page 63

Select Group
SG [g]
Description:
This command selects a set of groups. See "Group Selection" section above for a detailed
description on how this works.
Parameters:
[g] – Group selection bitmap, 1-Hex digit.
Example:
SG A
SG F
Select Input
SI [dddd] [bus] [src #]
Description:
This command selects a preview or program input source for the specified destination.
Parameters:
[dddd]
[bus]
[src #]
Example:
SI 7 V 8
SI 1 G 1
SI 27 P 12
Transition Setup
TRNSETUP [[type]=[value]] <[type]=[value]> ... <[type]=[value]>
Description:
This command allows the setup of the transition parameters. These parameters are used when
either an "AUTO TRANS" key is pressed or the ATRN command is used.
Parameters:
At least one set of parameters must be specified. [type]=[value] are defined as follows:
[type]
R
MR
ET
EW
Example:
TRNSETUP MR=3.0
TRNSETUP ET=1 R=1.2 EW=4
Manual #26-0111200-00 / Revision E
Selects GROUPS 2 and 4
Selects GROUPS 1, 2, 3, and 4
– bitmap of selected destinations, maximum of 4-Hex digits
– bus selection, V or P = Preview, G or M = Program (Main)
– 1 to 8 for FC-0608, 1 to 12 for FC-0612, 1 to 16 for FC-0616
Selects input 8 to preview screens 1, 2 and 3
Selects input 1 to program screen 1
Selects Input 12 to preview screens 1, 2 and 3 and sets AUX 1 to get Input
12 on the next transition.
[value]
0.0 to 5.0 seconds
0.0 to 5.0 seconds
1 to 12
0 to 6
Single-screen transition rate
Multi-screens transition rate
Transition effect type specification.
1=Dissolve
2=Wipe Left
3=Wipe Right
4=Wipe Up
5=Wipe Down
6=Curtain Close
Effect width specification.
0=256 pixels
1=128 pixels
2=64 pixels
3=32 pixels
Sets multi-screens transition rate to 3 seconds.
Set transition effect type to Dissolve, single-screen rate to 1.2
seconds, and edge width to 16 pixels.
ScreenPro Multi-Screen Remote
Description
7=Curtain Open
8=Mosaic
9=Multi-Curtain Close
10=Multi-Curtain Open
11=Multi-Wipe Right
12=Multi-Wipe Left
4=16 pixels
5=8 pixels
6=4 pixels
59