Destination, Program & Preview Selections; Transition Selection - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Changing the Single Screen Transition Rate
1. Select a single screen effect from the Patterns keypad.
2. Press and hold the USER RATE key on the Patterns Keypad. The VFD display will show a prompt to turn
the joystick knob to adjust the rate. Turn the joystick knob to set the desired rate and release the USER
RATE key. The rate can be changed from 0.0 to 5.0 seconds in 0.1 second increments.
Changing the Multi Screen Transition Rate
1. Select a multi screen effect from the Patterns keypad.
2. Press and hold the USER RATE key on the Patterns Keypad. The VFD display will show a prompt to turn
the joystick knob to adjust the rate. Turn the joystick knob to set the desired rate and release the USER
RATE key. The rate can be changed from 0.0 to 5.0 seconds in 0.1 second increments.
The transition rates can also be changed by holding down the WIPE or MIX keys and turning the joystick knob.
Presets can be used to save and restore these rates. Refer to the PRESET section for more information on saving
and restoring presets.
Destination, Program, and Preview Selections
The DESTINATION keys are used to identify which PROGRAM and PREVIEW input sources will be routed to a
particular output (destination) screen. Although six destination keys are available, the number of useable keys is
determined by the number of ScreenPROs in the system. The controller automatically determines the number of
active ScreenPROs and will ignore key presses of destination keys for ScreenPROs that are not installed. The
PROGRAM and PREVIEW keys correspond to an input source. Up to eight sources are available. The controller
cannot tell if a video source is configured or not, so it is up to the user to configure the input video sources correctly.
Configuring Destination Screens
1. Press and hold the desired destination Screen key.
2. Press and release one Program key corresponding to the input to be routed to this screen's program output.
3. Press and release one Preview key corresponding to the input to be routed to this screen's preview output.
4. Release the destination screen key.
The destination screen is now configured. The T-bar, CUT, and AUTO TRANS keys will now transition the output on
the selected screen between preview and the program input source.
When transitions are performed, the PROGRAM and PREVIEW keys will change to indicate that a transition has
occurred. During a transition, both PROGRAM and PREVIEW keys may be illuminated to show that the output
information contains video from both sources.
Configure the other screens using the same procedure.
At any time, pressing and holding a destination Screen key will illuminate the Program and Preview keys associated
with that destination screen.
The system presets can be used to save and recall these screen configurations as well. Refer to the system preset
section for more information on programming the system preset keys.
The ALL key on the Destination key row can be used to select or configure all available output screens
simultaneously.
The CLEAR key on the Destination key row is used to disable all output screen destinations simultaneously.
Transition Selections
Two transition keys are available: CUT and AUTO TRANS. Additionally, the T-BAR is used to perform manual
transitions. These controls determine how video outputs are "transitioned" between the PREVIEW and the
PROGRAM video input sources.
CUT immediately changes the output from the configured PROGRAM to the configured PREVIEW video source for
the selected Destination(s).
Manual #26-0111200-00 / Revision E ScreenPro Multi-Screen Remote 33