Picture-In-Picture Operation - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Picture-In-Picture Operation

This section describes how to perform Picture-in-Picture effects using the PIP Functions.
This capability will allow the operator to seamlessly transition a (Picture-In-Picture) PIP over the top of the main
output using any of the currently available transition effects. Below is a description of how to operate the PIP
Functions:
1. Select the desired source as a picture-in-picture (PIP) and this source will be displayed on the preview
monitor. This step can be performed on any of the Preview Screens as necessary.
2. To enable PIP for a screen or screens, press PIP 1, PIP 2, PIP 3, PIP 4, PIP 5, or PIP 6 which correspond to
screens 1, 2 3, 4, 5, and 6 respectively. Note that the selected PIP key must have an associated output
screen (ScreenPRO) configured or the controller will ignore the key press. The screen(s) chosen to be in
PIP mode will automatically size to 50% of normal and will be placed in the upper left hand corner of the
corresponding Preview screen.
3. To size and position the PIP, hold down the PIP # key for the screen you wish to adjust and use the XY-axis
on the joystick to position the PIP and the joystick knob to size the PIP.
4. To transition the PIP onto the main screen, press the AUTO TRANS or CUT key. The T-BAR can be used
as well.
5. Pressing the AUTO TRANS or CUT keys while the PIP image is on the main output caused the PIP to be
transitioned off of main leaving the background image showing.
6. To return a PIP image to its normal size, hold down the PIP # key and press the CLEAR PIP key.
7. If the PIP is cleared while the PIP image is on the main output, the PIP is transitioned off immediately using
a Dissolve and the image is returned to full size.
8. If any of the PROGRAM keys for a PIP output are pressed while a PIP is displayed on the PROGRAM
output, the PIP is transitioned off immediately using a "Cut". After the transition, the new source selection is
made.
PIP settings can be saved using the PATTERNS keypad and recalled to any PIP Preview screen. System presets
also can be configured to restore PIP information, however PIP recalls are only made to the Preview screens.
PIP is not available if keying is enabled on an output screen. For example, if keying is enabled on screen #3 (KEY 3),
pressing PIP 3 would not be allowed.
Manual #26-0111200-00 / Revision E ScreenPro Multi-Screen Remote 35