Next Preset Key; Pip Presets - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

We need to make a few assumptions before beginning:
Screens 1 & 3 are our GFX Screens
Screen 2 is assigned our I-Mag Screen
The Preset we will build will have the following information:
Screens 1 & 3 will have Input 8
Screen 2 will have Input 1 (cam 1)
(All Screens will use a 1.0 sec rate with a wipe-down effect)
Learning a Preset
On the Destination Bus push the Clear key and then select Screens 1 and 3. On the Preview bus, select Input 8
(PVW on Screen 1 & 3 switches will change to 8). Then select the Wipe-Down Effect on the Effect keypad and set the
Rate to 1.0 sec.
Now, push the Clear key again and then select Screen 3 on the Destination Bus (Screens 1 & 3 will be dark). On the
Preview bus select Input 1 (our Cam 1). At this point, all the information that we wanted is in a Preview state.
On the Destination Bus select Screens 1 and 3. At this point Screens 1, 2 and 3 will be the active destinations on the
preview bus, which is what we want learned to the Preset.
Note: Any information on Destinations (on the preview bus) NOT selected (unlit), will not be saved to a Preset when
learned.
Press and release Preset Page key until the PG: field on the controller display shows 1.
Press and hold the Learn key, and press Preset 1. The information is now learned to Preset 1 and can be recalled to
Preview at any time.
Changing Preset Information
Once a Preset is recalled (always to PVW), suppose you want to switch Screen 2 (the I-Mag screen & record deck)
from Input 1 (cam 1) to Input 2 (cam 2).
To do this:
Press and hold Screen 2 on the Destination Bus, and select input 2 on the Preview bus.
The new input is now in Preview and you can make the transition. If you want to save this change to Preset
1, press and hold Preset Learn and select Preset 1. The change is now saved.
If this is a one-time change and you want keep Preset 1 as it was originally learned, simply do not re-learn it.
When Preset 1 is recalled again, it will still have Input 1 (cam 1) learned to it.
Viewing a Preset
Press the Preset Page key until the PG: field on the controller display shows the desired page number. Press a
Preset memory key. The information learned to that memory location, if programmed, will go to Preview, and the
appropriate Destination and Preview Input source buttons will light. If the selected preset key does not light, no
information was stored in that preset and there is no information available to recall.

Next Preset Key

The NEXT PRESET key will allow the user to cycle through all available presets without having to press a preset
button. For example, if Presets 1,2 and 4 have saved information and Preset 4 is currently recalled, pressing Next
Preset will recall Preset 1 into Preview. Pressing the Next Preset key again will recall Preset 2 and so forth. The user
still has to initiate a transition for this look to go to program.
It is possible that Multiple Input sources will be lit on the Preview bus because each destination is capable of having a
different input source. You can press and hold an individual Destination switch on the Destination Bus and the
Preview and Program bus will go dark except for the inputs associated with the selected Destination.

PIP Presets

To save PIP size and position parameters for quick recall, size and position an image in Screen 1 Preview. (PIP
presets are only learned from Screen 1 Preview.) Hold the Learn key down and then press the PIP A, PIP B, PIP C or
Manual #26-0111200-00 / Revision E ScreenPro Multi-Screen Remote 13