Software Requirements - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Software Upgrade Instructions
Overview
The ScreenPro remote controller and the ScreenPro units incorporate the system software in a Flash memory
component. Flash memory allows easy upgrades without the need to send the unit back to the factory due to
software changes.
The loader utility provides the capability to update the system Flash module with the latest revision of software. The
upgrade utility can be run on any high capacity disk or solid-state drive.
Hardware Requirements
* IBM compatible computer with an available COM port
* Serial cable conforming to EIA RS-232 specifications (i.e. Standard Modem cable)
(The cable should have a DB-9 male connector on one end)

Software Requirements

* Window 95/98/NT/2000
* Flash File Loader
* SCREENPRO Software files
* Folsom Research Controller Software files
The Flash File Loader with the Software files can be downloaded from our FTP site
as described below.
Connecting to Folsom Research
Folsom Research's FTP site address is:
If you are using an FTP client, logon to our site using "anonymous" for the user
name and your email address as the password (ex. johndoe@somecompany.com).
However, if you are using a web browser to access our FTP site, point the browser to: ftp://ftp.folsom.com.
Downloading Necessary Files
ScreenPro Software Files and Flash File Loader
Directory Location: ftp://ftp.folsom.com\ Products \ Video \ SPR2000 \ FC_0608 Controller
File to download: "SP_SPP_Rev###_###.exe"
Installing ScreenPro Remote, ScreenPro's Software Files and Flash File Loader
Before installing the files, it is recommended that all running programs be properly shut down.
1) Click on the Start button and select Run.
2) Click on the Browse button and locate the "SP_SPP_Rev###_###.exe" file on your hard drive.
3) Double click on this file and then click OK to start the installation process.
4) Follow the on screen instructions to complete the install.
*** NOTE: Before proceeding, do the following: ***
1) Power on the remote controller unit.
2) Wait for the controller to finish booting.
3) Press the SYSTEM key on the Configuration Keypad.
4) Press the Down Arrow key to highlight SOFTWARE VERSIONS and press the
If the VFD shows <-SYSTEM SW VER 1.00, you must do the following (otherwise skip to the section titled "Starting
the Controller Flash File Loader Utility")
Manual #26-0111200-00 / Revision E
ftp.folsom.com
(Right Arrow) key.
ScreenPro Multi-Screen Remote 41