Patterns Keypad; Transition Rates - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Patterns Keypad

The PATTERNS keypad is used to select the WIPE PATTERN, control the transition rate, and save and recall PIP
presets. The currently selected wipe pattern, currently enabled effect (mix or wipe), and the user rate are displayed
on the system status display (first three lines of the VFD display).
Patterns
MULTI
MULTI
USER
REV
RATE
PIP PIP PIP PIP
A B C D
Wipe Patterns
When Wipe is selected (key is illuminated) from the TRANSITION controls, you can use any available pattern to
control the transitions performed by the T-Bar or AUTO TRANS key. The "REV" key will reverse any of the selected
patterns, i.e., "wipe left" when reversed will be come "wipe right." Patterns noted as "Multi" are designed for multi-
screen effects and require at lease two ScreenPROs to be installed in the system.
Multi-Curtain
multi
When selected for 2 or more screen wipes, Multi-Curtain will begin in the center and open each screen in
progression. The "REV" Key can be used to select a Multi-Curtain close.
Multi-Wipe
When selected for 2 or more screen transitions, Multi-Wipe will begin at the left and wipe each screen
progressively, to the right. The "REV" Key can be used to select a Multi-Wipe from right to left. Non-Multi patterns will
transition each selected screen simultaneously with the same pattern. "REV" will reverse the wipe on the selected
pattern.
PIP A, B, C, and D are user programmable PIP size and position settings. To program these keys, adjust the PIP on
Preset 1 to the desired position. Press and hold LEARN and press and hold either PIP A, B, C, D for 2 seconds. The
PIP configuration is saved to the specified PIP preset key. To recall this PIP setting, press and hold the desired PIP
key on the PIP Functions controls and select the PIP A, B, C, or D key. The saved PIP settings will be recalled to the
specified PIP screen on the Preview bus.

Transition Rates

The Transition Rate is user-definable. There are 2 adjustable rates. The first is the Standard Rate, which is used
when dissolving a single-screen Pattern or Mix Effect.
The second Rate is to adjust the "WIPE" (M_RATE on the status display) rate for transitioning single and Multi-
Pattern Effects. This information is always displayed on the system status lines of the VFD display.
Manual #26-0111200-00 / Revision E ScreenPro Multi-Screen Remote 32