Freeze Function Operation; Black Program And Black Preview - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

If a user wishes to distort the aspect ratio of the link, please refer to the SYSTEM DEFINE WINDOWS section of the
manual to make the adjustments on a screen-by-screen basis.
To Disable Link Mode:
1) Press the PIP Link button to turn this mode OFF.
2) At this point, the mode is disabled. However, the PIP will not be cleared. This must be manually done by
using the CLEAR PIP key while holding a PIP # key.
NOTE: It is essential that the Output Resolution of the Linked destinations be the same. This is due to the fact that all
sizing and moving calculations are based on the output resolution. If the output resolutions differ, PIP alignment
across multiple screens will not appear to be correct.
Please make note of the following when adjusting the Horizontal or Vertical size of a PIP.
The scaler is limited to a maximum 2:1 compression. Therefore, the size of a full PIP ("full" meaning the entire input
image is displayed in the PIP) is limited by the following equations:
Min Horizontal Size (% of output image) = InputHSamples/(2 * OutputHRes) * 100
Min Vertical Size (% of output image) = InputVActive/(2 * OutputVRes) * 100
Note: InputHSamples may not be the same as input horizontal resolution due to oversampling.
Example:
PIP source is standard video 710x485.
Output is XGA 1024x768.
Min Horizontal Size (%) = 710/(2 * 1024) * 100 = 34.67%
Min Vertical Size (%) = 485/(2 * 768) * 100 = 31.58%
PIP sizes smaller than the calculated limits can still be used. However, the right and bottom edges of the screen
will be cropped.
See also DEFINE WINDOW in the SYSTEM Configuration Section for information on defining a video WINDOW that
is similar to PIP but allows a video source to be expanded across multiple output screens.

Freeze Function Operation

Three FREEZE control keys are available: CLEAR FREEZE, FREEZE PREVIEW, and FREEZE PROGRAM.
FREEZE PREVIEW will freeze the image on the currently selected Preview outputs for all active screens. Changing
the Preview configuration, however, will remove the freeze condition.
FREEZE PROGRAM will freeze the image on the currently selected Program outputs for all active screens.
Changing the Program configuration, however, will not remove the freeze condition from the Program outputs.
Press and hold the CLEAR FREEZE key and press and release the FREEZE PREVIEW or FREEZE PROGRAM key
to cancel the freeze condition on the outputs.
Note that transitioning a frozen image from the Preview Output to a Program Output (or a Program Output to a
Preview Output) will also transition the freeze state.

Black Program and Black Preview

The BLACK PROGRAM and BLACK PREVIEW keys can be thought of as two additional video sources. The BLACK
PROGRAM output can be assigned to any screen output the same way that an actual video source is assigned to an
output screen. The same is true of the BLACK PREVIEW source. The button(s) will illuminate while selected. These
sources may also be transitioned between Program and Preview. These sources can be cleared by selecting
another video source for the output screen(s).
Manual #26-0111200-00 / Revision E ScreenPro Multi-Screen Remote 37