Configuration Of Screenpro Units - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Configuration of ScreenPro Units

NOTE: Use the chart below to help determine which software is compatible between systems. Other combinations of
software are NOT guaranteed to operate properly. If you are unsure about the software versions you have, consult
the factory for assistance. This table is subject to change without notice. Please check the web site
(www.folsom.com) for current information.
Release Number
1
2
3
4
5
6
7
8
ScreenPro units must be powered up and configured for remote control before the controller is turned on. To
configure the ScreenPro units, connect them as shown in the wiring diagram in the Technical Description section of
this document and then turn the units on. After a 50 second initialization period, the ScreenPro units will display the
Main menu.
To enter remote control mode, press the MISC key on the ScreenPro front panel. Use the ADJUST control knob to
scroll down to the item labeled EXT REMOTE CTRL. Press the SELECT key to select the external control feature.
The ADJUST control can now be used to select among the supported modes of operation. Use the ADJUST knob to
select the proper mode (SPR EXT ID #1 for Screen 1, SPR EXT ID #2 for Screen 2, SPR EXT ID #3 for Screen 3,
SPR EXT ID #4 for Screen 4, SPR EXT ID #5 for Screen 5, or SPR EXT ID #6 for Screen 6). Note that each
ScreenPRO must be configured with a unique ID number, the first ScreenPRO must have ID #1, and screens must
be assigned sequentially from left to right. After the proper mode is selected press the SELECT key to activate the
selected mode. The display will indicate the selected remote control settings and the backlighting of the lamps on the
front panel will be turned off to remind the user that remote control mode has been selected.
To exit remote control mode and re-enable the ScreenPRO front panel, select STANDALONE mode in the EXT
REMOTE CTRL menu and press the SELECT key. The ScreenPro unit will return to stand alone mode and the keys
will again be backlit.
Manual #26-0111200-00 / Revision E
ScreenPro Software
25.00.P – 25.00.T
31.00.A
31.00.A
31.00.A
35.00.C
35.00.D
5.02
5.03
Software Compatibility Chart
FC-0608 Controller Software
Versions Prior to 2.10
2.10
2.20
2.22
2.55
2.55
5.02
5.03
ScreenPro Multi-Screen Remote
BlendPro Software
N/A
N/A
N/A
N/A
1.03 or higher
1.03 or higher
1.03 or higher
1.03 or higher
11