FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual page 31

output to become distorted. Also, some of the video on the top and bottom will be cropped when zooming
the image. Use the +/ON key, -/OFF key, and joystick knob to adjust this parameter.
SYSTEM DEFINE WINDOWS H CENTER
This selection is used to specify the center, in percent, of the horizontal window. 0 is the center of the
screen. 100% is the left edge; -100% is the right edge. Use this adjustment to position the image as desired
on the output screen. Use the +/ON key, -/OFF key, and joystick knob to adjust this parameter.
SYSTEM DEFINE WINDOWS V CENTER
This selection is used to specify the center, in percent, of the vertical window. 100% is the top, 0% is the
center, and –100% is the bottom edge. Use this adjustment to position the image as desired on the output
screen. Use the +/ON key, -/OFF key, and joystick knob to adjust this parameter.
SYSTEM DEFINE WINDOWS RESET
This selection is used to clear any settings and adjustments made in this menu. Use the +/ON key to reset
the values to factory defaults.
Define Windows Example:
This example will enlarge an input source to fill three output screens horizontally starting at the top of the image. The
lower portion of the image will be cropped. Set up output screens 1, 2, and 3 in the DEFINE WINDOWS menu as
follows:
Screen: 1
Output:: PREVIEW
Mode: ON
H Size: 300
V Size: 300
H Center: 100
V Center: 100
SYSTEM TRANSITION EDGE
This is a global adjustment that determines the fuzziness of the Wipe Edge for all of the Wipe Transitions.
The selectable options are: 4, 8, 16, 32, 64, 128 and 256 with the units being pixels. The default is 16. Use the +/ON
and -/OFF keys to change the selection.
SYSTEM VFD BRIGHTNESS
This adjustment determines the brightness of the controller's VFD display. To avoid "burning-in" the display, use the
lowest setting possible. This is changed using the +/ON and -/OFF keys as well as the joystick knob.
SYSTEM SOFTWARE VERSIONS
This selection displays the software version information for all ScreenPROs and BlendPros in the system as well as
for the controller. For proper system operation, all ScreenPROs should be updated with the same software version.
SYSTEM TECH SUPPORT
Look at this menu for current tech support numbers that can be used on a 24/7 basis.
Manual #26-0111200-00 / Revision E
2 3
PREVIEW PREVIEW
ON ON
300 300
300 300
0 -100
100 100
ScreenPro Multi-Screen Remote 27