Serial Remote Commands - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Serial Remote Commands

ATRN <G=[g]|D=[dddd]>
BPQUERY [BP query command]
FSB [dddd] [bus]
FZ [dddd] [bus] [mode]
GA [groupNum] [dddd]
HELP or ?
KEY [sn] [mode] <threshold>
KP [row#] [key#]
KPR [row#] [key#]
KR [row#] [key#]
NBP
PASS [RS485 command] [checksum]
RE [user preset file #]
RP [user preset file #]
SD [dddd]
SG [g]
SI [dddd] [bus] [source #]
TRNSETUP [[type]=[value]]
Controller Serial Command List/Description
Auto Transition
ATRN <G=[g] | D=[dddd]>
Description:
Performs an Auto Transition on the destinations or groups if specified. If NOT, the operation will be
applied to the currently selected destinations. The currently selected Effect type, rate, and edge
width will be used to transition preview to program. See the TRNSETUP command for changing the
transition rates, type, and edge width.
Parameters:
The argument to this command is optional and is used to either select a set of groups or
destinations. For group selection, set the argument to G=[g], where g is the group bitmap. For
destination selection, set the argument to D=[dddd], where dddd is the destination bitmap.
Example:
ATRN
ATRN G=3
ATRN D=000B
ATRN D=3C
BlendPro Query
BPQUERY [BP query command]
Description:
Queries a BlendPro for raw binary data. The controller will transmit everything contained in the
argument field to the RS485 port, then waits for a reply. Data validation is done on the response,
and if there was no data corruption, the raw binary data will be sent back to the originator. If no
response is received or there was data corruption, controller will retry this operation 3 times before
giving up.
Parameters:
Manual #26-0111200-00 / Revision E
Performs an auto transition on the destinations or groups if specified. If
not, the operation will be applied to all currently active destinations.
Queries BlendPro for raw binary data.
Forces program or preview bus of the selected screens black.
Freezes/Unfreezes program or preview for selected screens.
Assigns specific destinations to a group.
Displays the available commands and brief description.
Luminance keying control for a particular screen at a given threshold.
Emulates a key press.
Emulates a key press and an immediate key release.
Emulates a key release.
Displays the number of BlendPros and their RS485 IDs.
Pass the RS485 command to the RS485 port when there's no
checksum error.
Recall the specified user preset file followed by an auto transition.
Recall the specified user preset file.
Select destination(s) as indicated by the destination bitmap.
Select group(s) as indicated by the group bitmap.
Select a preview or program input source for the specified
destinations.
Transition parameters setup.
Transition Preview to Program on currently selected destinations.
Transition Preview to Program on those destinations defined by Groups 1 and 2.
Transition Preview to Program on Screens 1, 2, and 4.
Transition Preview to Program on Screens 3, 4, 5, and 6.
ScreenPro Multi-Screen Remote 55