FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual page 47

Starting the Controller Flash File Loader Utility
1) After the files have been installed the ScreenPro Flash File Loader can be selected to run.
2) Click on the Start button and select Programs.
3) Find the Folsom Research folder and select SP and SPP with Controller Loader.
Preparing to Upgrade the ScreenPro Unit and Controller
1) Plug the DB-9 male connector into the port labeled "CONSOLE" on the back of the Remote Controller unit.
2) Make sure the other end of the cable is attached to the available COM port on the back of the computer
performing the upgrade.
3) In the loader program, click on the RS232 Config menu and select COM Port.
4) In the Communication Settings window, select the COM port the ScreenPro Remote Controller is attached to
by clicking on the appropriate COM # choice.
5) The ScreenPro Remote Controller defaults to a baud rate of 57600 baud (57.6K).
Verifying Communications between the Computer and ScreenPro Remote Unit
Note: Turn on and set up the ID(s) for the ScreenPro unit(s) in the EXT CONTROL submenu contained in the MISC
Menu. Make sure a 25pin straight-through cable is attached between the Controller and the ScreenPro system.
1) Turn the ScreenPro Controller ON or do a power cycle if it was previously powered on and wait for it to boot.
2) Note that the DCD and the CTS lights will be RED after you turn on the Controller.
3) If communications is established, the terminal window will display various messages and finally end with:
4) Back at the Controller display screen, make sure the correct number of screens is listed under the SCN
label. If the wrong number of screens is listed, power cycle the ScreenPro Remote Controller and all
attached ScreenPros. Wait for the ScreenPros to boot completely. Verify the cable(s) between the
ScreenPro(s) and check that their IDs are setup. Now power cycle the Controller and see if the correct
number of screens is listed.
5) If any of the communication parameters are changed within the loader, it is recommended that the
ScreenPro Remote Controller unit be powered cycled and the verification process started over.
Manual #26-0111200-00 / Revision E
CTRLR>
ScreenPro Multi-Screen Remote 43