Input Selection; Group Functions; Learning Groups - FOLSOM ScreenPRO FC-0608 Installation And Operator's Manual

Input Selection

Note: To select an Input source for a transition, you must have a Destination selected. If no Destination is selected,
the Preview and Program buses will not be active. The exception to this rule is when a Preset is selected. Presets
store the selected destination(s), input, rate, and transition effect, and will be recalled when selected.
When a Destination is selected, the keys associated with the Preview and Program inputs for that Destination will
light on the Preview and Program bus. Naturally, when just one Destination is active, only one input key on each bus
will be illuminated. If multiple destinations are selected, multiple input keys will be active.
The below diagram illustrates multiple destinations with multiple sources:
Presets
1 2 3
9 10 11
17 18 19
25 26 27
Destination
Screen Screen Screen Screen
1 2 3
Program
1 2 3
Preview
1 2 3

Group Functions

The user can combine multiple Destinations and "assign" them to a group. This allows Destinations that commonly
follow each other to be selected quickly for an action. Any combination of Destinations can be assigned to a group.
Put simply, Groups are preset combinations of Destinations that you want to switch together. The ScreenPro Multi-
Screen Remote has 4 user-definable Quick Groups.
Individual control of destinations is always possible, whether they have been assigned to a group or not.

Learning Groups

In this example we will build groups with the following destinations:
Group 1 will contain Screen 1, 3 and Aux 1 and 2.
Group 2 will contain Screen 2 and Aux 4.
To create this scenario, first push and hold the Group 1 key. The destinations currently assigned to this Group will
light in the Destination Bar. While holding Group 1, push Screen 1, then Screen 3, then Aux 1 and finally Aux 2. If any
other lights in the destination bus are illuminated, simply push these keys to extinguish the lights and unassociated
those destination with this Group. Now you can release the Group 1 key.
Next, push and hold the Group 2 key and then push Screen 2 and then Aux 4. Just as before, if any other lights in the
destination bus are illuminated, simply push these keys to extinguish the lights and unassociated those destination
with this Group.
To verify that the Groups have been assigned correctly, simply push Group 1. Screens 1 and 3 along with Aux 1 and
2 should be the only active destination keys to light in the Destination Bus. By pushing the Group 2 key, Screen 2 and
Aux 4 will become the only active destinations. All other destinations will become unlit along with the Group 1 key.
If you want Screen 1, 2 and 3 along with Aux 1, 2 and 4 to be active, simply push the Group 1 and 2 keys
simultaneously.
Manual #26-0111200-00 / Revision E
4 5 6 7
12 13 14 15
20 21 22 23
28 29 30 31
Screen Screen
All Clear
4 5 6
4 5 6 7
4 5 6 7
8
Preset Black
16
Learn
Page Preview
24
32
PIP Clear PIP
Link PIP 1
Clear Key
8
Key 1
Group Functions
Group Group Group
8
1 2 3
Functions
Black Clear Freeze
Program Freeze Preview
PIP Functions
PIP PIP PIP
2 3 4
Key Functions
Key Key Key
2 3 4
Transition
Group
Wipe Mix
4
ScreenPro Multi-Screen Remote
Freeze Next
Program Preset
PIP PIP
5 6
Key Key
5 6
AUTO
CUT
TRANS
16