Barco Nio MKII Installation & User Manual page 106

General tips
Open the "Windows Display Control Panel" by one of the two
1.
methods below:
Start > Settings > Control Panel > Display
a)
or
Open the "Display Properties Control Panel" by right
b)
clicking in an empty area on the desktop, then select
"Properties".
Click on the "Settings" tab.
2.
Select the rectangle that represents the Barco Coronis display
3.
whose settings you wish to change.
If you are using the VGA capabilities of your BarcoMed N
Note:
display controller, the resolution for the first display may be set to
a VGA resolution of "640 x 480" pixels with 16 colors and a default
refresh rate. If your BarcoMed N
the display may not be enabled yet. To enable the display, check
the "Extend my Windows desktop onto this monitor" checkbox,
but do NOT click the "Apply" button at this time.
If you installed your B
mode (default for Windows 2000) there will be one rectangle for
the virtual display representing the two heads controlled by each
BarcoMed N
If you installed your B
mode (default for Windows XP) there will be a rectangle
representing each head controlled by each BarcoMed N
controller. This will be true even if you have only one display
connected to your BarcoMed N
display controller cannot be enabled at the same time unless their
display properties match. If necessary detach the second display of
the BarcoMed N
clicking on the rectangle that represents it, deselect "Attached"
and click the "Apply" button.
Since Windows will not let you detach the primary display
Note:
connected to a particular controller, you may need to temporarily
make another display the primary display
106
N
ARCO IO
display controller.
IO
N
ARCO IO
display controller you are working with by right
IO
controller is not running VGA,
IO
Display System drivers in SingleView
Display System drivers in DualView
controller. Both displays of a
IO
IO
display
IO
Nio MKII