Assembly Configurations - Axminster AS408 User Manual

Assembly Configurations...

W
A X M I N S T E R
W H I T E
Option 1
The table (E) can be repositioned to be used when the linisher is raised in the up-right
position, see instruction below.
Fig 39
Clamping nuts
Loosen the linisher's clamping nuts, see fig 39, remove the workstop plate (H), see fig 40
(refer to step 4) raise the linisher & clamp in place. Loosen the bolt to the side of the sander,
insert the table support rod (D) into the machined hole & tighten using a 14mm spanner
(See figs 40 & 41). Slide the table (H) onto the rod as described on page 13 & tighten using
the lower lift & shift handle (b) (See fig 32).
Fig 41
Place a 90˚ degree square on the table and check that the table (E) is perpendicular to the
belt (See fig 42). If it requires adjustment, loosen the upper lift & shift handle (a), see fig 32
until correct. Re-tighten the lift & shift handle (a).
15
Table to Linisher Assembly
D
E
Fig 40
H
Fig 42