Axminster AS408 User Manual page 14

Assembly...
W
A X M I N S T E R
W H I T E
Locate the table support rod (D) loosen the bolt to the left side of the sanding disc, insert
the table support rod (D) & tighten the bolt using a 13mm spanner (See fig 29). Locate the
table (E), Offer up the machined hole to the base of the table (E) to the support rod (D)
slide it onto the support rod so the edge of the table is just clear of the sanding disc (J),
place a level on the table, adjust until the table is level. Clamp the table using the lower lift
& shift handle (b) (See figs 30,31 & 32).
Fig 29
13mm
Spanner
Fig 31
Make sure the bubble is
between the black lines.
Fig 33
Place a 90˚ square on the table & check that the table is perpendicular to disc
Place a 90˚ square up against the sanding disc (J) & check that the table (E) is
perpendicular to the disc (See figs 33 & 34). If it requires adjustment loosen the upper lift &
shift handle (a), see fig 32 until correct & re-tighten.
NOTE: Check that the pointer is reading ZERO on the scale. If not undo the phillips
13
screw and adjust until correct, re-tighten the screw (See fig 32).
D
J
Pointer
Upper lift & shift handle (a)
Lower lift & shift handle (b)
J
E
Fig 30
E
Fig 32
a
b
Fig 34