Assembly - Axminster AS408 User Manual

In order to reduce the footprint of the machine for packaging, several items are dismounted
from the machine and need to be re-affixed.
Step 1
Drive Belt Assembly
Fig 1
a
Loosen the two nuts (a) clamping the
linisher, using a 13mm spanner.
Fig 3
Loosen the phillips screw beneath the
linisher, allowing the motor assembly to
move freely.
Fig 5
Hold the drive belt & turn the phillips screw clockwise to push the motor down, thus putting
tension on the drive belt. Note: make sure there is sufficient tension otherwise the
belt will slip and you will have no drive. When you are satisfied screw the nut down
(see fig 3), so it is flush against the casting to prevent the phillips screw from moving.
Raise the linisher to the upright position,
re-tighten the two nuts (a).
Nut
Locate the drive belt (b) and slot the belt
over both pulleys. Note: You my need
to turn each pulley to fit the belt.

Assembly...

Fig 2
Fig 4
b
Fig 6
W
A X M I N S T E R
W H I T E
08