Setting The Applicator Roller; Changing The Position Of The Dispensing Edge - Avery Dennison ALS 341 User Manual

Operators Manual
ALS 341
Adjust the pressure rollers so that they are positioned over the middle of the material. Adjust
the brush so that it applies no more pressure to the label web than is necessary to keep it tight
during dispensing. If there is more than one brush fitted, only the brush before the label sensor
should be adjusted with any significant pressure; any other brushes should apply only the
minimum pressure required to hold the label web in position.

3.3 Setting the applicator roller

For some applications, it may be necessary to move the applicator roller relative to the
dispensing edge. To do this, loosen the two screws indicated in the diagram and pivot the roller
to the correct position before re-fastening the two screws.
Figure 7 Applicator roller

3.4 Changing the position of the dispensing edge

If your machine is equipped with a lead-screw adjustable dispensing edge, you may change the
position of the dispensing edge relative to the product. The lead-screw adjustable dispensing
edge allows adjustment towards or away from the product. The position can be read from the
scale on the dispensing arm bars.
Release 4/04 Page 15 Starting the labeller