Service Menu; Handling The Service Menu - Avery Dennison ALS 341 User Manual

Operators Manual
ALS 341
will be placed closer to the front side of the product. The possible variation of the
value is 10mm up to 999.9mm.
Contrast: This function adjusts the sensitivity of the standard optical label sensor. If the
function is called, the display shows maybe CX30. The C indicates that the
Contrast function is active. In this mode, the machine doesn't react to a
product start. The X appears in the display when the label sensor detects a label
on the label web. The X in the display corresponds to the yellow LED on the label
sensor.
The value (0-63) represents the sensitivity of the sensor.
To change contrast values press the Contrast key. If you hold the key for
approximately one second, the counting direction in the display reverses.

2.2 Service menu

In these menu settings can be done to configure the machine. In addition, some test functions
are available. The access to this menu is protected by a password.
The sequence to enter the password will be started by pressing simultaneously both speed
keys.
If CODE is displayed enter the password:
1 * Speed up
2 * Speed down
3 * Contrast
These are the functions within the service menu:
P_S_ Selection leading or trailing edge of product start sensor
S_S_ Selection leading or trailing edge of label start sensor
PRDL Product length (to disable multiple label starts)
ON3F Enable error message for rewinder
LOOP Loop speed control: Fast (250) or smooth (2000) speed
MDIR Machine dispense direction
DTST Continuos test
I_CH Input check
O_CH Output check
RWCH Position dancer arm of rewinder
LABC Label counter
QUIT Leave menu
2.2.1

Handling the service menu

Select a function:
Select value of a function:
Change value of a function:
Back to select a function:
Release 4/04
Press FEED key
Press Contrast key
Press FEED key
Press Contrast key
Page 10 Short form instruction