Table of Contents
Advertisement
4
O
PERATION
4.4 S
ETTINGS IN THE EXTENDED MENU
Check setting
Call up the STOD function.
Set the value for STOD to „0".
Confirm the value using the ENTER key and exit the
function.
Press the FEED key.
– A label is dispensed.
– The leading edge of the next label should rest exactly
on the dispensing edge [78].
Remove a single label from in front of the
sensor [79].
Press the FEED key.
– A label is dispensed [80A].
– The gap on the label ribbon should be automatically
compensated for [80B].
– The leading edge of the following label should rest
exactly on the dispensing edge [80C].
After the check:
– Check the label stop position (STOD); refer to
Page 55.
[78] The leading edge of the following label should rest on the dis-
pensing edge
[79] Remove a single label from in front of the sensor
A
[80] After pressing the FEED key:
A A label is dispensed
B The gap on the label ribbon should be automatically compen-
sated for
C The feed stops, the leading edge of the following label should
rest on the dispensing edge
74
ALS
350
450
B
C
Advertisement
Table of Contents
