Table of Contents
Advertisement
4
O
PERATION
4.4 S
ETTINGS IN THE EXTENDED MENU
Label distance
4.4.7
The label distance is defined as [76]:
Label distance = label length + gap
The shape of the labels or reflective surfaces can
cause a false signal to be sent from the label stop sen-
sor. In such a case, the label distance must be manual-
ly set.
Set distance
In the extended menu:
Call up the LPIT function.
Set the desired distance.
– Settings are possible in 0.1 mm steps:
Minimum: 5 mm
1)
Maximum: 350 mm
Confirm the value using the ENTER key and exit the
function.
Check setting.
Check setting
Press the FEED key.
If the setting is correct:
– A single label is dispensed at a constant dispensing
speed. The label completely separates from the
backing material and no wrinkling occurs.
If the setting value for LPIT is too large:
– 2 labels are dispensed.
If the setting value for LPIT is too small:
– A single label is dispensed.
– Because the value for LPIT is too small, the control
unit prematurely anticipates a signal from the label
stop sensor. The missing signal triggers automatic
label compensation. This error is indicated if:
– The dispensing speed is excessively fast at
the trailing edge of the label.
– If a printer is connected, the device will print
more than once.
1) Possible at reduced dispensing speeds (up to 999 mm); Refer to the serv-
ice guide.
(LPIT)
B
[76] A Label distance
B Label length
C Gap
72
C
A
ALS
350
450
Advertisement
Table of Contents
