Preparing A G350 Without An S8300 For Configuration - Avaya G350 Installation Manual

Preparing for configuration
Step 1: Prepare configuration equipment
Preparing a G350 without an S8300 for
configuration
If some of the configuration will be done on-site and some remotely, the supporting technician will
perform the local configuration and set up the G350 for the remote configuration. You will need to assist
the technician (see
If all the configuration will be done remotely (see
to enable a modem on the CON port of the G350 and connect the modem, as follows:
1
Prepare a PC with a CD-ROM drive and a TFTP server on the network. This may be needed for
installing software and firmware upgrades.
NOTE:
When uploading firmware from the S8300 using TFTP, you may need to enable TFTP
service in the Set LAN Security parameters of your web server.
NOTE:
Firmware upgrades for the G350 and media modules can either be installed from CD or
downloaded from the Web.
2
Download GIW (Gateway Installation Wizard) from the Avaya website
(support.avaya.com/avayaiw) to the laptop computer. The laptop should be running Windows
2000 or Windows XP to support GIW.
3
Plug one end of the provided flat RJ-45 to RJ-45 cable into the provided DB-9 adapter.
4
Plug the RJ-45 connector at the other end of the cable into the CON port of the G350.
5
Plug the DB-9 end of the flat cable into the COM port of the laptop computer.
6
From your laptop computer, double-click the GIW icon to run GIW. The opening screen appears:
34
Assisting a combined remote and on-site configuration on page 40).
Step 2: Assist the configuration
Installation of the G350 Media Gateway
on page 40), you need
December 2003