Inserting Media Modules - Avaya G350 Installation Manual

Installing the Avaya G350 Media Gateway
Step 2: Install the media modules
5
Apply firm pressure to engage the connectors.
The connector has different length pins. The long pins will engage first to provide grounding.
Medium length and short pins will provide power and signal.
6
Lock the S8300 Media Server module into the chassis by tightening the spring-loaded captive
screws on the front of the module.
7
Replace the plate labelled "Remove before removing or inserting S8300 module" between slots
V1 and V2, and tighten the screws on the front of the plate.
!
DANGER:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to radiated emissions requirements, all captive screws must be
securely tightened such that they cannot be loosened without the use of a tool.

Inserting media modules

After you have inserted the S8300 Media Server module, if applicable, insert the rest of the media
modules. Make sure to insert each module in a permissible slot. For information about which slots to
allocate to which modules, see
CAUTION:
Hold media modules only by the edges to avoid damage from static electricity. Do not
touch the top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-
static bag.
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
misaligned and then forced into position.
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the spring-
loaded captive screws. Use a screw driver to ensure the captive screws are securely
tightened to prevent damage to the equipment.
To insert a media module:
1
Remove the blank plate from the empty bay.
2
Position the media module squarely before the selected bay on the front of the G350 chassis and
engage both sides of the module in the interior guides.
3
Slide the module slowly into the chassis, maintaining an even pressure to assure that the module
does not become twisted or disengaged from the guides.
26
Allocating slots on page 23.
Installation of the G350 Media Gateway
December 2003