Configuring The G430 Using The Giw; Preparing For A Remote Configuration Of The G430 - Avaya G430 Quick Start For Hardware

12. To perform an on site configuration using the GIW, continue with
GIW on page 27. To prepare for a remote configuration, continue with
configuration of the G430

Configuring the G430 using the GIW

1. From the Wizard Usage Options screen, select Continue the installation using this wizard, and
click Continue.
2. On the Initialize Components screen, check the options that are appropriate for your installation.
3. On the Import EPW screen, import the Electronic Pre-Installation Worksheet (EPW) that was prepared.
4. Use the IP Address screen to configure addresses and communication parameters for the G430.
Click to configure the following information for the media gateway:
a. To specify the details of the Primary Management Interface of the G430, use the PMI screen.
b. To specify SNMP community strings and trap destinations, use the SNMP screens.
c. To specify the Media Gateway Controller(s) used to manage the G430, and the Transition Point
information, use the MGC List screen. Click Ping Test to test the accessibility of each MGC.
5. On the Firmware screen, identify the TFTP server used for file transfer, and specify the firmware
upgrade files to load.
6. Use the Change Master Key - Optional screen to optionally change the master key which is used to
encrypt gateway secrets (passwords, etc.) in the gateway configuration file.
7. If you have a service contract, the Gateway Authentication screen displays the installed gateway
Authentication file.
8. Review the status of the Field Replaceable Units (FRU) in the FRU Status screen.
9. On the TFTP Server screen, configure the media gateway TFTP server capability to upload IP Phone
configuration files.
10. You can configure the modem in the modem configuration screens.
11. Optionally change the root password on the media gateway.
12. Click Finish to complete the G430 configuration.

Preparing for a remote configuration of the G430

If you need to prepare the G430 for a remote configuration, you must attach a modem and enable it using
the GIW.
1. From the Wizard Usage Options screen, select Enable the modem for remote installation, and click
Continue. The Modem Type Selection screen appears.
2. Select the type of modem you are using, and click Continue.
3. Verify that the modem parameters are correct for the type of modem that you selected. Click
Continue. The Connect Modem screen appears.
4. From the Connect Modem screen, click Finish to exit the Gateway Installation Wizard.
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
on page 27.
DRAFT - January 25, 2009 - 1:38 PM
Configuring a G430 without an S8300 Server
Configuring the G430 using the
Preparing for a remote
Issue 1 May 2009 27