Connecting The Usb Modem - Avaya G350 Installation Manual

The G350 is now prepared for remote configuration via the USB modem. See
configuration on page 40) for information about how you will need to assist the supporting technician to
configure the G350 from a remote location.

Connecting the USB modem

If your installation includes an S8300 Media Server module, you need to connect the USB modem to the
S8300. After the G350 is configured, you can leave the modem permanently connected to enable the
S8300 to report alarms to remote locations.
To connect and enable the modem:
1
Connect the USB modem to a working telephone line.
2
Connect the modem to one of the USB ports on the S8300 module.
3
Connect the laptop computer to the Services port on the S8300 module.
4
Configure the network settings on the laptop to the following settings:
— TCP/IP properties. Set the laptop's TCP/IP properties as follows:
— Browser settings. Configure the browser for a direct connection to the Internet. Do not use
proxies.
The names of the dialog boxes and buttons vary on different operating systems and browser
releases. Use your computer's help system if needed to locate the correct place to enter this
information.
5
Enable the modem as follows:
a
Open the browser on the laptop.
b
Browse to 192.11.13.6. The Avaya web pages logon screen appears.
c
Enter your S8300 initial entry username in the Logon ID box.
d
Press OK. A Password box appears.
e
Enter your password in the password box.
Installation of the G350 Media Gateway
December 2003
•
IP address:
192.11.13.5
•
Subnet mask: 255.255.255.252
•
DNS Configuration:
Disable DNS
Preparing for configuration
Step 1: Prepare configuration equipment
Step 2: Assist the
37