Using The Reset Button - Panasonic KX-TD308 Installation Manual

6.1 Troubleshooting
PROBLEM
During a power failure,
extensions connected to
jack numbers 1 do not
operate.
Originating an outside call,
Call Transfer, or
Conference cannot be
performed.
6.1.4

Using the Reset Button

PROBABLE CAUSE
• A DPT or APT is
connected to the jack.
• The dialing mode (tone
or pulse) is improper.
The corresponding CO
button does not exist on the
proprietary telephone.
If the system does not operate properly, use the Reset Button.
Before using the Reset Button, try the system feature again to
confirm whether there definitely is a problem or not.
Pressing the Reset Button causes the following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
All other data stored in memory is not cleared.
Operation
If the system does not operate properly,
1. Press the Reset Button with a pointed tool.
When the power supply stops, certain extension is automatically
connected straight to specific outside line:
Extension (T, R) of jack number 1 .........................CO 1
Connect a standard telephone to the above extension jack.
POSSIBLE SOLUTION
• Disconnect the DPT or APT and
connect a standard telephone.
• Set the Tone / Pulse switch to the
other position.
Program the CO button. See
Section 4.2 [005] "Flexible CO
Button Assignment".
Troubleshooting 6-5