Panasonic KX-TD308 Installation Manual page 32

2.1 Before Installation
Warning:
Static sensitive devices are used.
To protect printed circuit boards
from static electricity, do not touch
connectors indicated to the right.
To discharge body static, touch
ground or wear a grounding strap.
2. If cables are run on the floor, use protectors to prevent the wires
from being stepped on. Avoid wiring under carpets.
3. Avoid using the same power supply outlet for computers, telexes,
and other office equipment. Otherwise, the system operation may
be interrupted by the induction noise from such equipment.
4. Please use one pair telephone wire for extension connection of
(telephone) equipment such as standard telephones, data terminals,
answering machines, computers, voice processing systems, etc.,
except Panasonic proprietary telephones (e.g. KX-T7433, KX-
T7436, KX-T7230, KX-T7235).
5. Unplug the system during wiring. After all of the wiring is
completed, plug in the system.
6. Mis-wiring may cause the system to operate improperly. Refer to
Section 6.1.1 "Installation" and Section 6.1.2 "Connection".
7. If an extension does not operate properly, disconnect the telephone
from the extension line and then connect again, or turn off the
Power Switch of the system and then on again.
8. The system is equipped with a 3-wire grounding type plug. This is
a safety feature. If you are unable to insert the plug into the outlet,
contact your electrician to replace your obsolete outlet. Do not
defeat the purpose of the grounding-type plug.
9. Outside lines should be installed with lightning protectors. For
details, refer to Section 2.3.2 "Outside Line Connection – Installing
Lightning Protectors".
Warning: Static sensitive connectors
Installation 2-3