User Programming - Panasonic KX-TD308 Installation Manual

4.1.4 User Programming Mode
Entering the user programming mode
Note
Some programming items are accessible by any display proprietary
telephone user in the system.
The programming items are listed below:
[000] Date and Time Set
[001] System Speed Dialing Number Set
[002] System Speed Dialing Name Set
[003] Extension Number Set
[004] Extension Name Set
[005] Flexible CO Button Assignment
[006] Operator/Manager Extension Assignment
[008] Absent Message
[009] Quick Dial Number Set
You can access these programs by entering the User Programming
Mode as follows:
Before entering the mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone
Press PROGRAM (or PAUSE) +
Password (default: 1234)
After entering the mode, perform the same programming steps as
the system programming steps in each program address.
• If your telephone set does not have a PROGRAM button, substitute it
with the PAUSE button.
• If nothing is entered in five seconds after the PROGRAM (or PAUSE)
button is pressed, it is cancelled.
• The User Password is not shown on the display. The password can be
changed by system programming. Refer to Section 4.3 [120] "User
Password".
• During the programming mode, your extension is treated as a busy
extension.
• Only one proprietary telephone can be in programming mode at any one
time.
+ and enter the User
System Programming 4-13