Table of Contents
Advertisement
5
.
1
1
.
5
C
a
l
l
C
5
.
1
1
.
5
C
a
l
l
C
Some applications require that the router be remotely activated, or be able to dial up to the
ISP via the ISDN interface. Vigor routers provide this feature by allowing user to make a
phone call to the router and then ask it to dial up to the ISP. Accordingly, a teleworker can
access the remote network to retrieve resources. Of course, a fixed IP address is required for
WAN connection and some internal network resource has to be exposed for remote users,
such as FTP, and WWW.
Call Control Setup
Basic Setup
VigorIPPBX 2820 Series User's Guide
o
n
t
r
o
l
o
n
t
r
o
l
Dial Retry - It specifies the dial retry counts per triggered
packet. A triggered packet is the packet whose destination
is outside the local network. The default setting is no dial
retry. If set to 5, for each triggered packet, the router will
dial 5 times until it is connected to the ISP or remote
access router.
Dial Delay Interval - It specifies the interval between
dialup retries. By default, the interval is 0 second.
Remote Activation – It can help users who would like to
access the server which is off the Internet in the head
office. To remotely make the server to be available on the
Internet, i.e. make the router in the head office activating
its Internet access either by dialing-up or starting
broadband connection, users can make a regular phone
call (the number is set in the Remote Activation field) to
the router as signaling it for activation. The phone call
will be soon disconnected once the router is on line.
Note that Dialing to a Single ISP should be
pre-configured properly.
Link Type - Because ISDN has two B channels
(64Kbps/per channel), you can specify whether you would
like to have single B channel, two B channels or BOD
(Bandwidth on Demand). Four options are available: Link
Disable, Dialup 64Kbps, Dialup 128Kbps, Dialup BOD.
267
Advertisement
Table of Contents
