For Vigorippbx 2820N - Draytek VigorIPPBX 2820 Series User Manual

Adsl router with ippbx feature
Hide thumbs Also See for VigorIPPBX 2820 Series:
Table of Contents

Advertisement

1
.
2
.
2
F
o
r
V
i
g
1
.
2
.
2
F
o
r
V
i
g
LED
ACT (Activity)
USB
CSM
WLAN
DSL
WAN 2
Line
Phone
QoS
LED on Connector
ISDN1/2
VigorIPPBX 2820 Series User's Guide
o
r
I
P
P
B
X
2
8
2
0
n
o
r
I
P
P
B
X
2
8
2
0
n
Status
Blinking
Off
On
Blinking
On
On
Blinking
On
Blinking
On
Blinking
On
Off
On
Off
Blinking
On
On
Left LED
(Orange)
Blinking
Off
Right LED
On
(Green)
Blinking
Explanation
The router is powered on and running normally.
The router is powered off.
A USB device is connected and active.
The data is transmitting.
The profile of CSM (Content Security Management) for
IM/P2P application is enabled from Firewall >>
General Setup. (Such profile is established under
CSM menu).
Wireless access point is ready.
It will blink while wireless traffic goes through.
If ACT and WLAN LEDs blink simultaneously when
WPS is working, and it will return to normal condition
after two minutes. (You need to setup WPS within 2
minutes.)
The router is ready to access Internet through DSL link.
Slowly: The modem is ready.
Quickly: The connection is training.
The WAN2 connection is ready.
It will blink while transmitting data.
A PSTN phone call comes (in and out). However, when
the phone call is disconnected, the LED will be off
about six seconds later.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
The QoS function is active.
ISDN-S0 (ISDN-NT) mode is active configured from
IP PBX>>PBX System>>Phone Settings and an
ISDN phone adapter is connected.
ISDN S0 (ISDN-NT) mode configured from IP
PBX>>PBX System>>Phone Settings
ISDN phone adapter is not connected.
It means ISDN TE mode is active which is configured
from IP PBX>>PBX System>>Phone Settings.
A phone adapter with phone set has been connected
(ISDN-S0) or ISDN line has been connected
(ISDN-TE).
ISDN-S0 (ISDN-NT) mode, it means an ISDN phone is
off-hook or a phone call comes.
In ISDN-TE mode, it means data, fax or voice (phone
call) is transmitting.
5
is
active and an

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vigorippbx 2820 seriesVigorippbx 2820n

Table of Contents