Proximity Tags; Screen Saver Option - Visonic PowerMax Complete User Manual

INTRODUCTION

Proximity Tags

When Partition is Disabled
Your system responds to valid proximity tags enrolled to
the system. The proximity tag enables you to perform a
variety of functions without entering user code, for
example, arming, disarming, reading the event log, etc.
Whenever the user code is required, you can simply
present a valid proximity tag and perform the desired
operation without the need to key-in your user code.
When Partition is Enabled
When the system is disarmed, after presenting a
valid proximity tag to the control panel, the message
"<OK> for AWAY" is displayed. Now you can press
the button to immediately arm the control
panel, or wait for 3 second for system automatic
AWAY arming (the message "Please exit now" will
be displayed). Presenting the proximity tag once
again will DISARM the system.
Instead of pressing the
you can press the
message "<OK> for HOME" / "<OK> for disarm" is
displayed, accordingly) and then press the press
button for HOME arming / disarming.
8
button (see above),
button once / twice (the
The control panel transmits an RF signal. A valid
proximity tag that is presented to the control panel
transmits a coded RF signal back to the control unit.

Screen Saver Option

The Screen Saver option (if enabled by the installer)
causes that when no key is pressed during more
than 30 seconds, the display is "PowerMax" and the
LEDs do not light (to prevent an intruder to know the
system status). The normal display returns after
pressing the button followed by entering user
code (Refresh by Code) or after pressing any key
(Refresh by Key), as selected by the installer.
If Refresh by Key was selected, the first pressing of
any key (except Fire and Emergency) causes normal
display return and the second press performs the key
function. Regarding the Fire and Emergency keys,
the first key press causes normal display return and
also performs the Fire/Emergency function.
D-302213