Xerox LightScribe User Manual page 29

•
If you have chosen to overwrite one
of the existing partitions/images, you
should see the following screen after you
submit your selection .
• If you have chosen Auto Generate, Then
precede to the next step .
Step 5: Please place your master disc into
the Reader or the 1st Writer if there's no
Reader installed in your duplicator . Once
the duplicator recognizes your master disc,
the loading progress screen will be dis-
played, as show below:
Loading...
FUN1.VEF 10% 401MB
• 4012MB indicates the total capacity of
your master disc.
• FUN1.VEF indicates the name of the
partition/image where the data is being
loaded into.
• 10% indicates the current percentage
of the master disc that has been loaded
into the hard drive.
• 401MB indicates the current amount
of data that has been copied from the
master disc.
Step 6: Once the loading process is com-
pleted, you should see the following screen:
4012MB
This Will Overwrite
[Fun.VEF
Then press >> to continue to
the next step.
Load Partition OK!
Press OK to Continue
You can then press the >>
button to go back to the Hard
Drive Setup menu. Then press
the << button to return to the
Main menu. You should see the
following screen:
Duplicator
9. Hard Drive Setup
Xerox LS Duplicator
]OK?
2.20
29