Table of Contents
Advertisement
Then press the >> button to submit .
b
You should see the following Specify
Counter screen:
Please refer to the "Input Name and
c
Number" section of "Chapter 2:
Getting to know your Duplicator" page
19, on how to enter the desired
amount . Then press >> to continue to
the next step .
Step 3: Once the Counter selection is
submitted, you shall see the following
Preparation screen and the corresponding
trays that do not contain disc(s) in them will
automatically be ejected:
Step 4: After you've placed your master
disc and blank discs in the drive(s), please
allow 5-10 seconds for the duplicator to de-
tect them . After they have been recognized,
then you shall see the following screen:
•
The "7" indicates there are seven discs
recognized by the Writer . Actual quantity
may be different depending on the size
of your machine or the number of discs
you inserted .
Specify Counter:
[
] OK?
Preparing
Waiting for Master
OR
Preparing
Waiting for Blanks
Note
If either one of the above
screens is displayed for more
than 2 minutes after you have
inserted your master disc or
blank discs, please check the
quality of the discs.
Preparing
7 Discs Detected, Go?
Note
By default, the "Auto Start" set-
ting is set to "Auto". Therefore,
if your duplicator is not com-
pletely filled with blank discs
and there is no activity within
30 seconds, or if all writers are
filled and the duplicator detects
this, the duplicator will start
automatically.
Xerox LS Duplicator
2
Advertisement
Table of Contents
