Section 1: Selecting The Copy Source - Xerox LightScribe User Manual

Table of Contents

Advertisement

Section 1: Selecting the Copy
Source.
When you turn on your duplicator, after it
has booted up, you should see the following
signifying your duplicator is ready .
Step 1: Use the up or down arrow button to
navigate to the Select Source menu .
Step 2: Press >> to enter the Select Source
menu and you shall see a screen similar to
this:
Step 3: If you plan to use the Reader as
the source, use the up or down buttons to
locate Drive 0 (1st drive) and press >> to
select it .
If you would like to use one of the Writers
as the source, use the up or down button
to locate Drive 1 or higher and press >> to
select it .
Once the source has been selected, you will
be guided to the main menu . You should
see the following screen:
Duplicator
1. Copy
Duplicator
7. Select Source
Drive 0
Port x.x
ASUS
DVD-RE818A
Drive 0
Port x.x
ASUS
DVD-RE818A
Drive 1
Port x.x
Pioneer DVD-RW DVR-1
Note
If the drive you've selected is
the same as the original source,
the duplicator will NOT respond
to the >> button. Please press
the << button to go back to the
main menu.
Duplicator
7. Select Source
Xerox LS Duplicator
2.20
2.20
2.20
21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LightScribe and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Lightscribe x.10

Table of Contents