Inputing Characters/Numbers - Xerox LightScribe User Manual

Inputing Characters/Numbers

When you operate this duplicator, there are
cases when you may be required to enter a
number or a name through the duplicator's
LCD panel . An example could be entering
the Counter quantity or a Hard Drive Parti-
tion/Image name .
To enter an alpha numeric character, you
need to use the up or down button to scroll
through various numbers or letters then use
the >> (Forward/Enter button) or << (Back/
Escape button) to move the cursor position
right or left . Once you've finished, move
the cursor to OK and press the >> button .
For example, if you want to enter a partition
name of "FUN1", do the following:
Press the down button repeatedly until
a
"F" is displayed .
Press the >>button once to move the
b
cursor to the next position .
Press the down button repeatedly until
c
"U" is displayed .
Press the >>button once to move the
d
cursor to the next position .
Press the down button repeatedly until
e
"N" is displayed .
Press the >>button once to move the
f
cursor to the next position .
Press the down button repeatedly until
g
"1" is displayed .
Press the >>button repeatedly to move
h
the cursor to OK . Then, press the
>>button once to submit your selection
and proceed to next step .
Note
The below example is meant as
only an illustration for entering
a partition name. For a more
detailed procedure descrip-
tion on how to create a new
partition/image, please refer to
Section 1: Loading Master Disc
content into the Hard Drive as
a partition/image of "Making
Hard Drive-to-Disc Copies" on
page 27.
Edit Partition Name:
[FUN1 ] , OK?
Note
When you enter a number,
normally it asks for a 4 digit
number. If your number is less
than 4 digits, you need to fill
the leading spaces with 0s (any
leading zeros will be skipped).
An example of that would be
0234 (Two hundred and thirty
four) or 0010 (ten).
Xerox LS Duplicator 19