Front Panel Removal
Remove the front panel from the system unit as follows.
1. Locate the two plastic tabs at the front of the chassis. They are indicated by
two arrows engraved on the chassis.
2. Press down on the two tabs and press in a third tab at the end of the panel to
release the panel (see the following figure).
3. Pull the panel away from the chassis.
Side Panel Removal
Remove the side panel from the system unit as follows.
1. Remove the system access cover and front panel as previously described.
2. Locate the two side panel securing tabs at the front of the system.
3. Pull the tabs out and away from the system.
4. Slide the side panel towards the rear of the unit and away from the unit.
Device Cage Removal
Remove the device cage from the system unit as follows.
1. Label and disconnect any cables connected to devices in the device cage.
2. Locate the screw on the front of the system between the 3.5-inch blank panel
and diskette drive (see the following figure). Remove the screw.
5-4 Disassembly and Reassembly
Releasing the Front Panel