Dedicated Windows For Cubase Series - Steinberg UR 824 Operation Manual

Information Window
This window indicates information about the
dspMixFx UR824 and the device.
Version Information
Indicates the version of the firmware and
software. The letters "x.x.x" and "x.xx" indicate
the version number.
Check for update
Checks whether or not you have the latest
software and firmware version, via the Internet. If
a new version is found, follow the on-screen
instructions for updating.
Dedicated Windows for
Cubase Series
These are the windows for configuring the device
settings from Cubase series. The Dedicated
Windows for Cubase series allow you to configure
the parameters which are configured by the
dspMixFx UR824. from Cubase series. Two types of
windows are available: Input Settings and Hardware
Setup.
Input Settings Window
This is the window for configuring the input settings
of the device. The signal flow is from top to bottom.
The settings on this window are saved to the
Cubase project file, except for the +48V indicator.
Hardware Setup Window
This is the window for configuring the general
settings of the device. Click the upper tabs to select
the window. Only the settings on the Reverb Routing
window are saved to the Cubase project file.
Panel Controls for the Software Programs
Screenshot
Input Settings Window
Hardware Setup Window
How to Open the Window
Input Settings Window
The Input Settings window appears in the following
windows.
•In the Mixer window (Cubase and Cubase Artist
only)
•In the VST Input Channel Settings window (Cubase
and Cubase Artist only)
•In the VST Audio Channel Settings window (other
Cubase series software)
In the Mixer Window (Cubase and Cubase
Artist only)
1.
[Devices]  [Mixer] to open the Mixer
window.
2.
Click "Show Extended View."
Operation Manual
UR824
14