Steinberg UR 824 Operation Manual page 10

Channel Area
This is the area for configuring the input channel
settings.
Channel Link
Turns on (lit) and off (dark) the channel link of two
adjacent channels. When you turn this on, two
mono channels will become one stereo channel.
Level Meter
Indicates the signal level.
High Pass Filter
Turns on (lit) and off (dark) the high pass filter.
To select the cutoff frequency of the high pass
filter, use the "Setup Window" (page 12) in the
section "dspMixFx UR824."
Phase
Turns on (lit) and off (dark) the phase inversion of
the signal.
Panel Controls for the Software Programs
Channel Strip Insertion Location
Selects the insertion location of the Channel Strip.
Option Description
MON.FX Applies the Channel Strip to only the
monitor signal (sent to the device).
INS.FX Applies the Channel Strip to both the
monitor signal (sent to the device)
and the recording signal (sent to a
DAW software).
Channel Strip On/Off
Turns the Channel Strip on (lit) and off (dark).
You can apply eight Channel Strip to the mono
channel, or four Channel Strip to the stereo
channel.
Channel Strip Edit
Opens (lit) and closes (dark) the "Channel Strip"
(page 18) setup window.
Effect Type
Indicates the effect type.
REV-X Send
Adjusts the signal level which is sent to the
REV-X.
Range: -∞ dB – +6.00 dB
Pan
Adjusts the pan.
Range: L16 – C – R16
Mute
Turns the mute on (lit) and off (dark).
Solo
Turns the solo on (lit) and off (dark).
+48V
Indicates the on/off status of the phantom power
function of the device.
Fader
Adjusts the signal level.
Range: -∞ dB – +6.00 dB
UR824
Operation Manual 10