Steinberg UR 824 Operation Manual page 29

*1The following chart indicates the Ch.Strip (Channel Strip) insertion location.
Upper (INS.FX)
From input on the device
Ch. Strip
To DAW
input
To output on the device
You can apply eight Channel Strips to mono channels, or four Channel Strips to a stereo channel.
*2 One of the MIX 1–4 signals can be sent to the REV-X.
*3 The built-in REV-X is equipped with an "FX Bus" which is used for sending the signal from DAW software to
the REV-X. For example, to send the recorded audio data to the REV-X, you can check the sound with the
REV-X, which is used for monitoring during the recording.
Lower (MON.FX)
From input on the device
To DAW
input
Ch. Strip
To output on the device
Not applied (OFF)
From input on the device
To DAW
input
To output on the device
UR824
Appendix
Operation Manual 29